To Clean The Product - Husqvarna ST 324 Bedienungsanweisung

the adjustment does not resolve the problem,
replace the auger belt. See
on page 19 .
To adjust the belt tension
1. Remove the belt cover. See
replacement of the belts on page 18 .
2. Loosen the idler pulley nut (A).
3. Slide the idler pulley closer to the belt to increase the
belt tension. Slide it away from the belt to decrease
the belt tension.
4. Tighten the idler pulley nut (A).
5. To make sure that the belt is declutched fully when
the auger lever is disengaged, have an assistant
stand 10 feet / 3 meters in front of the product, on
the opposite side of the chute. The assistant
observes the rotation of the auger, and measures
the time it takes for the auger to stop rotating when
the lever is released. If the auger stops rotating after
more than 5 seconds, repeat the adjustment and
slide the idler pulley further from the belt.
633 - 005 - 17.12.2019
To remove the auger belt
To prepare for
A
B
6. When the auger stops rotating after less than 5
seconds, install the belt cover. See
replacement of the belts on page 18 .
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin (B).
2. Remove the wheel from the axle (C).
A
B

To clean the product

• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
To prepare for
C
21