Inhaltsverzeichnis - Husqvarna RC 318T Bedienungsanweisung

Contents
Introduction
Pre-delivery inspection and product numbers.............3
Product description..................................................... 3
Intended use............................................................... 3
Insure your product..................................................... 3
Product overview.........................................................4
Electrical system overview.......................................... 5
Seat safety switch....................................................... 5
Hour meter.................................................................. 5
Battery.........................................................................5
Power outlet................................................................ 5
Ignition lock................................................................. 6
Forward and reverse pedals....................................... 6
Auger control switch with LED indicators.................... 6
Symbols on the product.............................................. 6
Product liability............................................................ 8
Safety
Safety definitions.........................................................8
General safety instructions..........................................8
Safety instructions for operation..................................9
Safety instructions for maintenance.......................... 12
Assembly
Introduction............................................................... 13
To attach the cutting deck......................................... 13
To remove the cutting deck.......................................14
Operation
Introduction............................................................... 15
To fill fuel...................................................................15
To adjust the seat......................................................15
To engage and disengage the drive system............. 15
To lift and lower the cutting deck...............................16
To adjust the sensor for collector full........................ 16
To start the engine.................................................... 16
To use the product in collect mode........................... 17
To use the product in non-collect mode.................... 18
To stop the engine.................................................... 18
To apply and release the parking brake....................19
To get a good mowing result.....................................19
Maintenance
Introduction............................................................... 19
Maintenance schedule.............................................. 19
To clean the product................................................. 21
To clean the engine cooling air intake.......................21
To clean the hydraulic oil cooler................................22
2
To remove blockage from the auger......................... 22
To remove the covers............................................... 22
To replace a broken lamp......................................... 23
To examine the steering wires.................................. 23
To do a check of the parking brake...........................24
To replace the fuel filter.............................................24
To clean and change the air filter..............................24
To replace a fuse...................................................... 25
To charge the battery................................................ 25
To set the tire pressure............................................. 25
To put the cutting deck in servicing position............. 25
To put the cutting deck in mowing position............... 26
To do a check of and adjust the cutting deck
ground pressure........................................................ 27
To do a check of the parallelism of the cutting
deck...........................................................................27
To adjust the parallelism of the cutting deck............. 28
To examine the blades..............................................28
To replace the blades................................................28
To do a check of the engine oil level.........................29
To replace the engine oil...........................................29
To change the oil filter...............................................29
To do a check of the transmission oil level............... 30
To lubricate the belt adjuster.....................................30
Troubleshooting
Troubleshooting schedule......................................... 31
Transportation, storage and disposal
Transportation........................................................... 33
Storage......................................................................33
Disposal.................................................................... 33
Technical data
Technical data...........................................................34
Service
Service...................................................................... 36
Warranty
Transmission warranty.............................................. 36
EC Declaration of Conformity
EC Declaration of Conformity....................................36
63 - 005 - 03.02.2017