The drive system lever for the front axle for RC 320Ts
AWD is found behind the left front wheel.
To lift and lower the cutting deck
To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
To lower the cutting deck to mowing position, press the
lock button and move the lift lever forward. If the engine
is running, the blades start to rotate automatically.
16
To adjust the sensor for collector full
If the hatch opens or the auger stops before the collector
is full, it is necessary to adjust the sensor for collector
full. There are 4 positions for the sensor for collector full.
To start the engine
1. Make sure that the drive system is engaged, see
engage and disengage the drive system on page 15 .
2. Lift up the cutting deck and apply the parking brake.
To
63 - 005 - 03.02.2017