To Clean The Hydraulic Oil Cooler; To Remove Blockage From The Auger; To Remove The Covers; Engine Cover - Husqvarna RC 318T Bedienungsanweisung

To clean the hydraulic oil cooler

Only for RC 320Ts AWD.
Make sure that the hydraulic oil cooling fan is not
blocked and that the area around the hydraulic oil cooler
is clean. Remove grass and dirt with a brush.

To remove blockage from the auger

If the symbol on the auger button is red and the product
beeps continuously, the auger is blocked. The blockage
must be manually removed.
1. Tilt the collector.
2. Pull the auger maintenance tool loose from the
bottom of the collector.
3. Put the auger maintenance tool into the hole at the
top part of the auger.
22
4. Hold the auger maintenance tool and turn the auger
counterclockwise 5 full turns. The cause of the
blockage is sent down and out of the auger.
5. Pull the auger maintenance tool out and put it back
into the holder on the bottom of the collector.
6. Lower the collector to operating position and start
the engine.
7. If the symbol on the auger button is red and the
product beeps when the engine starts, stop the
engine.
8. Put the cutting deck in servicing position and
manually remove blockage from the auger inlet.
9. Put the cutting deck in mowing position and start the
engine.
10. If the symbol on the auger button is red and the
product beeps when the engine starts, stop the
engine.
11. Let an authorized service agent help you.
Note: When the blockage is removed, the product starts
in non-collect mode and you must select collect mode
again.

To remove the covers

Engine cover

Tilt the collector to access the engine cover, remove the
3 screws and lift off the cover.
63 - 005 - 03.02.2017