Safety Cut-Off - EOS Moment Control W Montage- Und Gebrauchsanweisungen

Safety cut-off

The sauna heater is fitted with an overheating limiter (STB). In the case of a malfunction causing
a too high temperature this limiter will automatically cut off the power supply on all three phase.
The released overheating limiter has to be manually reset.
ATTENTION! Disconnect first the sauna heater from the power supply!
Press on the reset pin of the limiter through the small round opening in the outer housing by
using a pointed tool until you notice a click (see fig. 10).
The limiter is now reset and is the standard working position.
In the case the STB limiter releases again after the heater is switched on please let the heater be
checked by a specialist. Please contact your local dealer for technical assistance.
Fig. 10
Damage to the High Limiter
The high limiter (STB) can be damaged if the reset button is pressed without rectifying the
reasons of overheating. Improper reset of the high limiter can damage it, which may cause
its malfunction and lead to overheating and resulting damages.
• Identify and rectify the reason of overheating
• Allow at least 30 minutes to cool down the heater
33
EN