Installation And Connection; Installation; Quasi-Flush Mountable Sensors; Non-Flush Mountable Sensors - Balluff IO-Link BES M12MG1-YIC60B-S04G Betriebsanleitung

BES M12M_1-YIC_0_-S04G
Inductive sensors
4

Installation and connection

4.1

Installation

The product must be installed such that it is protected
from electromagnetic fields and mechanical damage.
4.1.1

Quasi-flush mountable sensors

Quasi-flush mount sensors require a space behind the
active surface which is free of conductive materials. The
minimum permissible distance between the active surface
and installation material is designated dimension X (see
Fig. 4-1).
For ferroelectric installation materials (such as iron, steel
and stainless steel) dimension X is 2.5 mm. With non-
electrically conductive installation materials (such as brass
and aluminum), the distance is 2 mm.
The deviation in the effective operating distance associated
with the installation is maximum 10%.
Fig. 4-1: Quasi-flush installation
4.1.2

Non-flush mountable sensors

Non-flush mountable sensors require a clear space behind
the active surface (see Fig. 4-2).
Fig. 4-2: Non-flush installation
8 english
4.2

Electrical connection

2
3 1
4
Fig. 4-3: Pin assignments (pin side view)
Pin Signal
1 + (operating voltage UB+)
2 DIO (Teach-in input (DI) / switching output (DO))
3 GND (operating voltage UB-; reference potential)
4 C/Q (IO-Link communication (C) / switching output
(Q))
Tab. 4-1: Plug connector pin assignment
1
4
2
3
Fig. 4-4: Connection diagram
+
C/Q
DIO
–