Installation And Connection; Installation; Electrical Connection; Shielding And Cable Routing - Balluff BAE SA-OH-060-YI-S75G Betriebsanleitung

BAE SA-OH-060-YI-S75G
Photoelectric Sensors
5

Installation and connection

5.1

Installation

For dimensions, see Fig. 4-1 on page 7.
The following mounting types of the sensor amplifiers are
available:
– Simple clamp mounting on DIN rail with dimension of
DIN 35 mm or 15 mm.
– Screw mounting by means of through holes for M3
screws.
– Clamp mounting on DIN rail adapter by means of M3
screws.
Place the device on the DIN rail adapter as shown. Con-
nect the cable according to the connection table.
Fig. 5-1: Mounting the amplifier
5.2

Electrical connection

2
4
1 3 1
4-pin (supply) 3-pin (sensor)
Connection Pin
L+ (operating voltage+
SIO 15...30V,
1 VDC
IO-Link 18...30V)
Max. current consumption: 45mA
4-pin
Digital input /
2 I/Q
(supply)
Digital output
3 GND L- (operating voltage- 0V)
IO-Link communication / digital
4 C/Q
output in SIO mode
1 LED+ Transmitter (LED)
3-pin
3 FT+ Receiver (phototransistor)
(sensor)
4 GND 0V / cable shield
Tab. 5-1: Pin Assignment
www.balluff.com
4
3
Signal
Factory setting
– Mode: SIO-Mode
– Operating mode: Standard Power, Standard
Sensor
– PIN 4: PNP switch output
(in IO-Link mode: Push-Pull)
– PIN 2: Inactive (PNP)
5.3

Shielding and cable routing

The BOH sensor cable is shielded and should not be
extended.
Cable length
For IO-Link operation, the maximum supply cable length is
20 m.
english
9