Unpacking - Storch Spider 2800 L Übersetzung Der Originalanleitung

SPECIAL SAFETY INSTRUCTIONS FOR SANDING
Use only sanding paper with the stated diameter of 225
mm for the Spider 2800 L. Using larger or smaller dia-
®
meters will damage the device.
FUNCTIONAL DESCRIPTION
This Electric Drywall Sander is specially designed for the
most efficient sanding of drywall or plaster walls and cei-
lings for both new construction and renovation work. It is
designed to work in conjunction with a vacuum cleaner
for minimum dust and best sanding results. The pivoting
sanding head allows excellent results with minimum time
and effort.
ELECTRICAL CONNECTION
The network voltage must be within the voltage range
indicated on the tool name plate. Under no circumstances
should the tool be used when the power supply cable is
damaged. A damaged cable must be replaced immedi-
ately by an by STORCH authorized Customer Service
Center. Do not try to repair the damaged cable yourself.
The use of damaged power cables can lead to an electric
shock.
EXTENSION CABLE
If an extension cable is required, it must have a sufficient
cross-section so as to prevent an excessive drop in voltage
or overheating. An excessive drop in voltage reduces the
output and can lead to failure of the motor. We recom-
mend a cross-section of 2.5 mm².

UNPACKING

Carefully remove the tool and all loose items from the
shipping container. Retain all packing materials until after
you have inspected and satisfactorily operated the machi-
ne.
Scope of delivery
Spider 2800 L, Carry Bag, Allen key, Instruction
®
manual.
DO NOT OPERATE THIS TOOL UNTIL YOU READ AND
UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
Original instruction
TO INSTALL A SANDPAPER DISC
1. Unplug the machine.
2. Remove the worn sanding paper pad, but leave the soft
hook-and-loop sanding pad attached
3. Carefully center the new sandpaper disc and press
into place. It will be held securely by the hook and loop
backing.
NOTE: The hook-and-loop sanding pad has 2 different
hook profile types. The black side has finer hooks, the
white side has coarser hooks. Choose the side on which
your hook-and-loop sanding paper adheres best.
REPLACING THE HOOK-AND-LOOP
SANDING PAD
The hook-and-loop sanding pad must be absolutely flat in
order to achieve good sanding results. If it is deformed or
damaged, this leads to uneven sanding. Always replace in
case of damage. It has hook-and-loop adhesion on both
sides. To change the pad, pull it off the backing plate and
attach a new pad by carefully centering it perfectly over
the backing plate.
SEALING BRUSHES AT THE EDGE OF
THE EXTRACTION HOOD
The sealing brush at the edge of the suction hood serve
two purposes: they keep the sanding pad correctly alig-
ned with the work surface and support the suction by the
vacuum. The sealing brushes become worn from long-
term use.
The extraction hood should be replaced if the sealing
brushes are too worn to ensure effective extraction and
stabilisation of the sanding head.
70