Installation And Connection; Installation; Electrical Connection; Shielding And Cable Routing - Balluff BOS R254K-UUI-PR10-S4 Betriebsanleitung

BOS R254K-UUI-PR/RS/RE10-S4
Photoelectric Sensors
5

Installation and connection

5.1

Installation

For dimensions, see Fig. 4-1 on page 7.
CAUTION
Red light
If you look into the light beam emitted by the transmitter,
temporary blinding and irritation of the eyes is possible.
► Locate transmitter units so that it is not possible to
look into the light beam even during operation.
The sensor can be fastened with two M4 screws.
Plug outlet direction:
Fig. 5-1: Example image of use with angled connector
8 english
5.2

Electrical connection

1
2 4
3
Fig. 5-2: Plug layout (top view of M12 plug on BOS)
Pin Signal
1 L+ (Operating voltage +, SIO 10...30 V,
IO-Link 18...30 V)
2 I/Q (Digital input / digital output / analog output)
3 L− (Operating voltage −)
4 C/Q (IO-Link communication / digital output in SIO
mode)
Tab. 5-1: Pin assignment
Factory setting
– Mode: SIO mode
– Object recognition operating mode: Standard
– PIN 2: Teach input (IN)
– PIN 4: Push-pull switching output (PNP-NO
contact and NPN-NC contact)
Also see document IO-Link configuration under
www.balluff.com on the product page.
5.3

Shielding and cable routing

Cable length
For IO-Link operation, the maximum cable length is 20 m.