Yamaha YZ250 Handbuch Seite 438

FRONT FORK
5. Measure:
9 Oil level (left and right) a
Out of specification ¡ Adjust.
Standard oil level:
145~148 mm (5.71~5.83 in)
From top of fully stretched
damper assembly.
6. Tighten:
9Locknut 1
NOTE:
Fully finger tighten the locknut onto the
damper assembly.
7. Loosen:
9 Compression damping adjuster 1
NOTE:
9 Loosen the compression damping adjuster fin-
ger tight.
9 Record the set position of the adjuster (the
amount of turning out the fully turned in posi-
tion).
8. Install:
9 Base valve 1
To damper assembly 2.
NOTE:
First bring the damper rod pressure to a maxi-
mum. Then install the base valve while releas-
ing the damper rod pressure.
9. Check that the damper assembly is fully
stretched.
Not fully stretched ¡ Repeat the steps 2 to 8.
5-34
CHAS