Yamaha YZ250 Handbuch Seite 428

FRONT FORK
Adjuster
1. Drain the outer tube of its front fork oil at its
top.
2. Loosen:
9 Adjuster 1
3. Remove:
9 Adjuster 1
NOTE:
9While compressing the inner tube 2 , set the
cap bolt ring wrench 4 between the inner tube
and locknut 3 .
9Hold the locknut and remove the adjuster.
cC
Do not remove the locknut as the damper
rod may go into the damper assembly and
not be taken out.
Cap bolt ring wrench:
YM-01501/90890-01501
EC553201
Inner tube
1. Remove:
9 Dust seal 1
9 Stopper ring 2
Using slotted-head screwdriver.
cC
Take care not to scratch the inner tube.
2. Remove:
9 Inner tube 1
Oil seal removal steps:
9 Push in slowly
fore it bottoms out and then pull it back
quickly b.
9 Repeat this step until the inner tube can
be pulled out from the outer tube.
5-29
CHAS
a the inner tube just be-