Yamaha YZ250 Handbuch Seite 174

FRONT BRAKE PAD INSPECTION AND REPLACEMENT
REAR BRAKE ADJUSTMENT/
EC364005
REAR BRAKE ADJUSTMENT
1. Check:
NOTE:
The brake pedal height is the vertical distance
from the inside top end of the footrest.
2. Adjust:
Pedal height adjustment steps:
9 Loosen the locknut 1.
9 Turn the adjusting nut 2 until the pedal
height a is within specified height.
9 Tighten the locknut.
w
9 Adjust the pedal height between the
maximum Å Å and the minimum ı ı as
shown. (In this adjustment, the bolt 3 3
end b b should protrude out of the thread-
ed portion 4 4 but not be less than 2 mm
(0.08 in) c c away from the brake pedal
5 5 ).
9 After the pedal height adjustment, make
sure that the rear brake does not drag.
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
2. Replace:
Brake pad replacement steps:
9 Remove the pad pin plug 1.
3-19
9 Brake pedal height a
Out of specification¡Adjust.
Brake pedal height a a :
Zero mm (Zero in)
9 Brake pedal height
9 Brake pad thickness a
¡ Replace as a set.
Out of specification
Brake pad thickness a a :
Standard
4.4 mm (0.17 in)
9 Brake pad
INSP
ADJ
<Limit>
1.0 mm (0.04 in)