Yamaha YZ250 Handbuch Seite 204

TIRE PRESSURE CHECK/SPOKES INSPECTION AND
TIGHTENING/WHEEL INSPECTION
EC36Q001
TIRE PRESSURE CHECK
1. Measure:
9 Tire pressure
Out of specification ¡ Adjust.
Standard tire pressure:
100 kPa (1.0 kgf/cm
NOTE:
9 Check the tire while it is cold.
9 Loose bead stoppers allow the tire to slip off its
position on the rim when the tire pressure is
low.
9 A tilted tire valve stem indicates that the tire
slips off its position on the rim.
9 If the tire valve stem is found tilted, the tire is
considered to be slipping off its position.
Correct the tire position.
EC36S002
SPOKES INSPECTION AND TIGHTENING
1. Inspect:
9 Spokes 1
Bend/Damage ¡ Replace.
Loose spoke ¡ Retighten.
2. Tighten:
9 Spokes
NOTE:
Be sure to retighten these spokes before and af-
ter break-in. After a practice or a race check
spokes for looseness.
EC36T000
WHEEL INSPECTION
1. Inspect:
9 Wheel runout
Elevate the wheel and turn it.
Abnormal runout ¡ Replace.
3-34
INSP
ADJ
2 , 15 psi)
3 Nm (0.3 m•kg, 2.2 ft•lb)