Yamaha YZ250 Handbuch Seite 410

FRONT BRAKE AND REAR BRAKE
4. Install:
[Front]
9 Master cylinder kit 1
9 Plain washer 2
9 Circlip 3
9 Master cylinder boot 4
To master cylinder 5.
[Rear]
9 Master cylinder kit 1
9 Push rod 2
9 Circlip 3
9 Master cylinder boot 4
To master cylinder 5.
NOTE:
9 Apply the brake fluid on the master cylinder
kit.
9 Apply the lithium soap base grease on the tip
of the push rod.
9 When installing the circlip, use a long nose
circlip pliers.
A Front
B Rear
EC5A5310
Front master cylinder
1. Install:
9 Master cylinder 1
9 Master cylinder bracket 2
9 Bolt (master cylinder bracket) 3
NOTE:
9 Install the bracket so that the arrow mark a
face upward.
9 First tighten the bolts on the upper side of the
master cylinder bracket, and then tighten the
bolts on the lower side.
2. Install:
9 Brake lever 1
9 Bolt (brake lever) 2
9 Nut (brake lever) 3
NOTE:
Apply the lithium soap base grease on the
brake lever sliding surface, bolt and contacting
surface of the master cylinder piston.
5-20
CHAS
9 Nm (0.9 m•kg, 6.5 ft•lb)
6 Nm (0.6 m•kg, 4.3 ft•lb)
6 Nm (0.6 m•kg, 4.3 ft•lb)