Storage; Installation; Commissioning; Operation - C.M.A. Astoria Plus 4 You TS SAEP Bedienungs-Und Wartungsanleitung, Anweisungen Für Den Benutzer

4.

STORAGE

The machine is stored by the Manufacturer or the
Distributor.
5.

INSTALLATION

The machine must only be installed by one of the
Manufacturer's Qualified Technicians.
When the machine is being installed, the Qualified Technician must
replace the water in the hydraulic circuits.
The machine's support base must be perfectly level and have no
irregularities.
The electric system must be equipped with a suitable 30 mA
residual-current device (RCD).
6.

COMMISSIONING

The machine must only be commissioned by one of
the Manufacturer's Qualified Technicians.
54 260
of
7.

OPERATION

Safety precautions

7.1
Carefully read the instructions provided in chapter 2 on page 44.

Emissions

7.2
VIBRATIONS
In conditions of use that meet the indications of cor-
rect use provided in this manual, any detected vibrations
do not give rise to dangerous situations.
SOUND EMISSIONS
The noise level emitted by the machine is on average
lower than 70 dB; therefore, there is no obligation to use
personal protective equipment for the auditory system.
If the machine emits unusual noises, the manufacturer
must be notified.
ELECTROMAGNETIC ENVIRONMENT
The machine is designed to work properly in any
industrial electromagnetic environment, falling within
the Emission and Immunity limits provided by current
standards.

Turning the machine on and off

7.3
7.3.1 Start-up
After the hydraulic and electrical mains have been
connected, make sure that the drain tray (5) under the
cup support grille is correctly connected to the drain.
4
Check that all the steam valves are closed. Turn on
the machine using the main switch (4) and follow the
indications on the machine's display.
5
USER manual