Energy Saving Management - C.M.A. Astoria Plus 4 You TS SAEP Bedienungs-Und Wartungsanleitung, Anweisungen Für Den Benutzer

Energy Saving Management

7.12
7.12.1 Programmed Energy Saving mode
When programmed, it automatically puts one or more
groups into standby mode when the workload decreases
and prepares them for full capacity when needed.
The following icon indicates the Energy Saving status
on the display:
To bring a dispensing group out of the standby mode,
press and hold the respective "PROG/STOP" button for
3 seconds.
It will return to full operation in about 1-2 minutes.
If the machine is in "ENERGY SAVING" mode, the steam
heating unit will also be reactivated, effectively exiting
from the "energy saving" mode.
The steam heating unit and the dispensing groups
that have been reactivated, will remain operative un-
til the next time limit set for the energy saving mode
(machine) or the standby mode (dispensing groups) to
start-up has passed.
The system will continue to follow the energy saving
settings that have been programmed.
The machine can also be set to OFF status, which is
indicated by the following icon on the display:
To reactivate the machine, press and hold down the
"PROG/STOP" button for 3 seconds.
Wait approximately 10 minutes for the coffee heating
unit to warm up and approximately 20 minutes for the
steam heating unit to heat up.
If the machine is not used for a time which exceeds
the limit that has been programmed, the machine will
return to the OFF status.
To change the operating parameters of the "Energy saving" system,
contact the technical support service.
62 260
of
7.12.2 Dispensing group standby mode
When desired, one or multiple dispensing groups can
be manually put in standby mode.
To force the groups into standby mode: g
Press the button on the touchscreen display;
On the next screen, activate the groups that you
would like to put in standby mode;
Return to the main screen via the
Groups
Standby
When the group has been put into standby mode,
this will be indicated by the beverage selection LEDs
turning off.
To bring a dispensing group out of the standby mode,
press and hold the respective "PROG/STOP" button for
3 seconds.
button.
P
rog
S
top
Press and hold
down for 3 secs.
USER manual