General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PAEXS 20-Li A1 Originalbetriebsanleitung

Noise and vibration data
Noise measurement value determined in
accordance with EN 62841 . The A-rated noise
level of the power tool is typically as follows
Sound pressure level
Sound power level
Uncertainty
Wear ear muffs!
Rated acceleration, typically
Main handle
Uncertainty
Additional handle
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with
a standardised test procedure and can be
used for comparison of the power tool with
another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece being worked, the
vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool .
► Try to keep the vibration load as low as
possible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting
the working time . Wherein all states of oper-
ation must be included (e .g . times when the
power tool is switched off and times where
the power tool is switched on but running
without load) .
PAEXS 20-Li A1
L = 82 .3 dB (A)
PA
L = 93 .3 dB (A)
WA
K = 3 dB
a = 10 .6 m/s
2
h
K = 1 .5 m/s
2
a = 18 .6 m/s
2
h
K = 1 .5 m/s
2
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illus-
trations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .

2 . Electrical safety

a) Power tool plugs must match the outlet.
Never modify the plug in any way.
Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock .
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of
electric shock if your body is earthed or
grounded .
GB │ IE │ NI │ 3 ■