Assembly; Required Tools - Bosch Rexroth SB356 Bedienungsanleitung

3 609 929 B67/2008-11 | SB356
6

Assembly

When installing the product, always observe
the ambient conditions specified in the
technical data (see "Technical data" on
page 41).

Required tools

• Screwdriver
Assembling the SB356 system box
CAUTION
Risk of damage to persons
and property!
Assembly of the SB356 system
box requires basic mechanical
and electrical knowledge.
y Only qualified personnel (see
"Personnel qualifications" on
page 24) are authorized to
assemble the SB356 system
box.
y Measures to prevent
electrostatic discharge (ESD
protection) must be
undertaken to protect the
module and system
components during all
assembly work.
y Observe the local, system-
specific regulations and
requirements; proper use of
tools, lifting, and transport
equipment; as well as the
relevant standards, provisions,
and accident prevention
regulations.
Bosch Rexroth AG
The system boxes can either be fastened to
walls or racks using the mounting brackets
on the rear or placed on their bases. The
installation position is horizontal. System
boxes can be lined up side-by-side to form
multi-channel tightening systems. System
boxes can only be lined up on top of each
other if a minimum distance of 300 mm is
observed.
WARNING!
Always keep the air ways for cooling clear.
The lifting devices and fixtures for the system
boxes must be designed to correspond to the
weights of the boxes (see "Technical data"
on page 41).
Four M8 DIN580 ring bolts are provided to
assemble the SB356.
Assembly height
The mains isolation device (mains switch)
must be installed at a height of 0.6 m to
1.9 m in accordance with EN60204-1. The
assembly height for the system boxes must
correspond to this requirement.
WARNING!
The system boxes must be bolted to the
lift-out protection
B
assembly graphic) to prevent the system
box from being unintentionally lifted out of
the suspension rail
P
A suspension rail with the appropriate length
is provided with the system box.
WARNING!
The system box may only be suspended
using the suspension rail supplied!
29/124
(see following
.