Connecting The Power Cord; Cautions Regarding Batteries; Allowed Operation Range Of The Remote Control Unit - Pioneer PDP-42RXE Benutzerhandbuch

Connecting the power cord

Preparation
Connect the power cord after all component connections are completed.
Plasma Display (rear view)
eparing the remote control unit
serting batteries
Open the battery cover.
Insert the supplied two AAA (1.5 V) size batteries.
• The battery polarities must correspond with the (+) and
(–) indicators in the battery compartment.
Close the battery cover.
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display, a three-core power cord with a
ground terminal is used for efficiency protection.
Always connect the power cord to a three-pronged
outlet and make sure that the cord is properly grounded.
Downloaded From TV-Manual.com Manuals

Cautions regarding batteries

• The remote control unit cannot operate the system if the
batteries in the unit are empty. When this happens, replace
the batteries with new ones.
• Do not use manganese batteries. When you replace the
batteries, use alkaline ones.
• Do not mix batteries of different types. Different types of
batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new
batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
• Do not leave dead batteries in the remote control unit;
chemical leakage will occur. If you find any chemical leakage,
wipe thoroughly with a cloth.
L
AUDIO
AV 3
• The batteries supplied with this product may have a shorter
Y
AV 1 AV 2 COMPONENT
ANT
INPUT
life expectancy due to storage conditions.
• If you will not use the remote control unit for an extended
Europe, except
period of time, remove the batteries from it.
UK and Eire
• WHEN DISPOSING OF USED BATTERIES, PLEASE
COMPLY WITH GOVERNMENTAL REGULATIONS OR
ENVIRONMENTAL PUBLIC INSTRUCTION'S RULES
THAT APPLY IN YOUR COUNTRY/AREA.
Allowed operation range of the remote control
unit
UK and
Operate the remote control unit while pointing it toward the
Eire
remote control sensor located at the bottom centre of the front
panel of the Plasma Display. The distance from the remote
control sensor must be within 7 m and the angle relative to the
sensor must be within 30 degrees in the right or left direction.
30°
R
L
R
HDMI AUDIO
P B P R
HDMI SERVICE ONLY
• Disconnect the power cord from the power outlet when the Plasma
Display is not going to be used for a long period of time.
Remote control
30°
sensor
05
AC IN
Power cord
En