Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Power Cord; Preparing The Remote Control Unit; Inserting Batteries; Operating Range Of The Remote Control Unit - Pioneer PDP-4270XA Bedienungsanleitung

Plasma-fernseher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 91
Preparation
Note
• Disconnect the power cord from the power outlet when the plasma
television is not going to be used for a long period of time.

Connecting the power cord

Rear view
Power cord

Preparing the remote control unit

Inserting batteries

1
Open the battery cover.
2
Load the supplied two AA size batteries while inserting their
respective negative polarity (–) ends first.
Place batteries with their terminals corresponding to the (+) and (–)
indicators in the battery compartment.
3
Improper use of batteries can result in chemical leakage or an
explosion. Be sure to follow the instructions below.
• When you replace the batteries, use manganese or alkaline ones.
Europe, except UK and
• Place the batteries with their terminals corresponding to the (+)
Republic of Ireland
• Do not mix batteries of different types. Different types of batteries
• Do not mix old and new batteries. Mixing old and new batteries can
• Remove batteries as soon as they have worn out. Chemicals that
UK and Republic of Ireland
• The batteries supplied with this product may have a shorter life
• If you will not use the remote control unit for an extended period of
• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY

Operating range of the remote control unit

Operate the remote control unit while pointing it toward the remote
control sensor (t) located at the bottom right of the front panel of the
plasma television. The distance from the remote control sensor must
be within 7 m and the angle relative to the sensor must be within 30
degrees in the right, left, upward, or downward direction.
Close the battery cover.
Caution
and (–) indicators.
have different characteristics.
shorten the life of new batteries or cause chemical leakage in old
batteries.
leak from batteries can cause a rash. If you find any chemical
leakage, wipe thoroughly with a cloth.
expectancy due to storage conditions.
time, remove the batteries from it.
WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL
PUBLIC INSTITUTION'S RULES THAT APPLY IN YOUR
COUNTRY/AREA.
30 º
7 m
30 º
Remote
control
sensor
05
19
En

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis