194 / 330
Bosch Rexroth AG
General information on damage to property and products
3.2
Installation and assembly
|
Electric Drives
and Controls
Metal burrs from drilling and sawing work
Possibility of short-circuits, damage to electrical equipment, unex
pected plant reactions!
"
All affected components in the switch cabinet should be well parti
tioned prior to all work!
Non-compliance will result in the extinction of any warranty
claims.
"
Remove all metal burrs carefully after work.
Water leakage while connecting cooling water lines
Possibility of damage to the electrical equipment, unexpected
plant reactions!
"
All affected components in the switch cabinet should be well parti
tioned prior to all work!
Non-compliance will result in the extinction of any warranty
claims.
"
Remove residual moisture carefully after work.
Leakage in the cooling fluid circuit
Possibility of damage to the electrical equipment, unexpected
plant reactions!
"
Install the water-cooled modules so that the units inside the switch
cabinet are sufficiently protected against leaking cooling water.
Heat accumulation caused by insufficient clearance
Possibility of temporary interruption of the welding process, a re
duced useful life of the product, destruction of the device, damage
to the electrical equipment, unexpected plant reactions!
"
Make sure that an installation clearance of at least 100 mm re
mains above and below the product.
PST 6xx0
NOTICE
|
1070080029 / 05