Installation Check-Up - LaCimbali M100 Serie Gebrauch Und Installation

5. Installation Check-up

WARNING: AFTER INSTALLATION, CHECK TO SEE IF THE MACHINE IS WORKING PROPERLY (see the
Installation Module C)
WATER CONNECTIONS
• No leaks from the connections or tubes
FUNCTIONING
• Boiler and operating pressures are normal.
• The pressure gauge is working properly.
• The self-levelling device is working properly.
• The expansion valves are working properly
WARNING: ONCE THE MACHINE HAS BEEN INSTALLED AND IS READY FOR USE, BEFORE ALLOWING
THE WORKER TO START USING THE MACHINE, WASH THE INTERNAL COMPONENTS ACCORDING
TO THE INSTRUCTIONS BELOW:
GROUPS
• Hook up the lter holders to the groups (without coffee).
• Let each group dispense water for about a minute.
HOT WATER
• GT - HD: continuously dispense hot water (pressing the appropriate button) until at least 5 litres of water have been
used.
DT: continuously dispense hot water (pressing the appropriate button) until at least 5 litres of water have been
dispensed for a machine with 2 groups, 8 litres for a machine with 3 groups and 10 litres for a machine with 4 groups.
See the "Hot water dispensing" chapter in the User's Manual.
STEAM (also with Turbosteam)
• Dispense steam from the nozzles for about a minute, using the appropriate buttons.
TURBO MILK (where applicable)
• After removing the intake tube from the milk container, carry out a few test cycles.
.
6 EN