Sound Menu - Yamaha YSP-800 Bedienungsanleitung

SOUND MENU

Use to manually adjust various parameters related to the
sound output.
SET MENU → MANUAL SETUP → SOUND MENU
1 SOUND MENU
. A)TONE CONTROL
B)BEAM LEVEL
C)SUBWOOFER SET
D)MUTE LEVEL
E)AUDIO DELAY
F)ROOM EQ
G)DD/DTS Dynamic Range
[ ]/[ ]:Up/Down
[ENTER]:Enter
■ TONE CONTROL (Tone control)
You can adjust the tonal quality of your speakers.
A)TONE CONTROL
.
TREBLE;;;;0dB
BASS;;;;;;0dB
[ ]/[ ]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
TREBLE (Treble)
Use to adjust the high frequency response.
Choices: –12 dB to +12 dB
Initial setting: 0 dB
BASS (Bass)
Use to adjust the low frequency response.
Choices: –12 dB to +12 dB
Initial setting: 0 dB
- +
p
■ BEAM LEVEL (Beam level)
Use to manually balance the speaker levels between the
front left or surround left speakers and each speaker
selected.
When setting the front right, center or surround left
speakers or the subwoofer, the test tone is output from the
front left speakers and the selected speaker position.
When setting the surround right speaker, the test tone is
output alternately from the surround left and right
speakers.
The factory default value is automatically set for this
parameter depending on the parameters set in AUTO
SETUP, BASIC SETUP or ROOM EQ in MANUAL
SETUP.
Depending on the beam mode settings, some channels
may not be available for selection. In this case, NONE is
displayed.
B)BEAM LEVEL
-
.
FR
C
SL
SR
SWFR
*OUT : FL )FR
*MODE: 5 BEAM
[ ]/[ ]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
• FR adjusts the balance of the front left and front right
speakers.
• C adjusts the balance of the front left and center
speakers.
• SL adjusts the balance of the front left and surround
left speakers.
• SR adjusts the balance of the surround left and
surround right speakers.
• SWFR adjusts the balance of the front left speaker and
subwoofer.
MANUAL SETUP
+
p
69