Playing Back Sources; Adjusting The Volume - Yamaha YSP-800 Bedienungsanleitung

PLAYBACK

Playing back sources

Once an input source is selected (see page 37), you can
play back the selected input source.
Note
This section uses a DVD player as an example of the playback
source.
y
For details on the TV and the DVD player you are using, refer to
the owner's manual supplied with the TV and the DVD player.
1
Turn on the power of your DVD player using
the remote control supplied with the DVD
player.
2
Switch to the video input on your TV using
the remote control supplied with the TV so
that the DVD menu screen is displayed.
3
If necessary, turn down the volume of your
TV until you cannot hear any sound.
4
Press DVD on the remote control to select
DVD as the input source.
DVD
5
Play back the DVD on your DVD player using
the supplied remote control.
Audio signals from your DVD player are output from
the speakers of this unit.
y
• If the output volume is too low, increase the volume on this unit
to around –25 dB.
• If you have set the appropriate remote control codes for your
TV and DVD player, you can use the remote control supplied
with this unit to operate these components. For details on how
to set remote control codes, see page 82.
38

Adjusting the volume

INPUT VOLUME
VOLUME
MUTE
Press VOLUME +/– on the front panel or on the
remote control to increase or decrease the
volume level.
The numeric value of the volume level appears in the front
panel display.
Control range: 0.0 dB to –99.5 dB, MIN (minimum)
+ +
VOLUME
Front panel
VOLUME MUTE appears at the minimum volume level.
Notes
• The volume level of all input sources (including multi-channel
as well as stereo sources) changes at the same time.
• 0.5 dB of the volume level increases or decreases each time you
press VOLUME +/–.
• You can continuously increase or decrease the volume level if
you press and hold VOLUME +/–.
+ +
STANDBY/ON
CH TV VOL
TV INPUT TV MUTE
VOLUME
or
Remote control
VOL
VOL