Beam Mode - Yamaha YSP-800 Bedienungsanleitung

BEAM MODE

You can change the beam mode to suit the input source of this unit using the beam mode buttons on the remote control
(STEREO, 3BEAM, 5BEAM, ST+3BEAM or TARGET). Select stereo mode for 2-channel sources, 3 beam mode, 5
beam mode and stereo plus 3 beam mode for 5.1-channel playback.
All the beam modes are available in the following cases:
• If you selected Parallel to Wall for INSTALLING in AUTO SETUP (see page 30)
• If you selected settings other than CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC
SETUP (see page 59)
• If you selected FLAT TO WALL for INSTALLED POSITION in MANUAL SETUP (see page 65)
Only stereo, stereo plus 3 beam and target modes are available in the following cases:
• If you selected Angle to Wall or corner for INSTALLING in AUTO SETUP (see page 30)
• If you selected CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 59)
• If you selected ANGLE TO WALL OR CORNER for INSTALLED POSITION in MANUAL SETUP (see page 65)
Beam
mode
Parallel to
Wall
STEREO Yes
3BEAM Yes
5BEAM Yes
ST+3BEAM Yes
TARGET Yes
Note
Yes: the corresponding beam mode is available.
No: the corresponding beam mode is not available.
40
BEAM MODE
AUTO SETUP
INSTALLING
(see page 30)
Angle to Wall
or corner
Yes
No
No
Yes
Yes
BASIC SETUP
INSTALLED POSITION
(see page 59)
CORNER
RIGHT
or Other settings
CORNER
LEFT
Yes Yes
No Yes
No Yes
Yes Yes
Yes Yes
MANUAL SETUP
INSTALLED POSITION
(see page 65)
ANGLE TO
FLAT TO
WALL OR
WALL
CORNER
Yes Yes
Yes No
Yes No
Yes Yes
Yes Yes