Basic Setup - Yamaha YSP-800 Bedienungsanleitung

If you cannot run AUTO SETUP successfully or if an error occurs during the AUTO SETUP procedure, you can use
BASIC SETUP to individually set the parameters of this unit in the following order:
1) ROOM TYPE (Room type)
2) INSTALLED POSITION (Installed position of this unit)
3) ROOM SIZE (Room size)
y
• You can save the settings optimized by the AUTO SETUP procedure (see page 34). A set of settings optimized according to specific
conditions of your listening environment can be recalled later depending on the varying conditions of your listening environment (see
page 35).
• In order to fine-tune the listening environment parameters, as well as to make advanced settings for speaker positions, sound beams,
digital input and the OSD, see MANUAL SETUP (see page 63).
• Items with an asterisk (*) appearing next to them may be displayed differently on your screen depending on your individual settings.
Note
Each listening environment parameter must be set before the next parameter in order is set.
YSP
5BEAM ST+3BEAM
1
STEREO
TARGET
4
MUSIC
7
SPORTS
0
CINEMA DSP
CH LEVEL
TEST
■ Displaying the SET MENU screen
1
Press YSP on the remote control to switch to
the operation mode of this unit.
YSP
2
Press MENU on the remote control.
The SET MENU screen appears on your TV.
MENU

BASIC SETUP

INPUTMODE SLEEP
3BEAM
2
3
5 6
MOVIE VOL MODE
8 9
OFF SURROUND
+10
MENU
ENTER
RETURN
SET MENU
. ;MEMORY
;AUTO SETUP
;BASIC SETUP
;MANUAL SETUP
[ ]/[ ]:Up/Down
[ENTER]:Enter
y
• The control buttons used for SET MENU are displayed on
the bottom of the screen.
• To return to the previous screen while using SET MENU,
press RETURN on the remote control.
• To resume cursor button operations after changing the
control area by pressing an input selector button, press
TEST on the remote control.
• To cancel the SET MENU screen, press MENU once
more.
• You can also perform the following operations in the front
panel display.
• If you press an input selector button during the SET
MENU operations, the cursor buttons become ineffective.
In this case, press TEST once.
3
Press / to select BASIC SETUP and
then press ENTER.
The following screen appears on your TV.
ENTER
BASIC SETUP
ENTER
;BASIC SETUP
. 1 ROOM TYPE ?
2
3
4
PUSH [ENTER] Key.
57