Connecting The Backrest To The Booster Seat; Placing It Onto The Vehicle Seat - Heyner MaxiFix AERO Bedienanleitung

The children's car seat should always be secured in the car, even when not in use by your child.
As long as the child car seat is not in use, protect it against intensive and direct sunlight. It can
become very hot if exposed to direct sunlight. Especially, the belt buckle heats up quickly.
After an accident it is required to replace the whole child restraint system or to send it to the
manufacturer for inspection - together with the accident report.
The child car seat should never be used without the original cover.
Should the seat cover need to be replaced, only use original HEYNER MOBIL AUTOMOTIVE GMBH
seat covers.
In case of difficulties, please contact your dealer or the manufacturer.
Check the Isofix guides regularly and clean away any dirt, dust or food particles as they may
effect the safety of the system.
Use the vehicle type list of your manufacturer to check which vehicle seats are suitable for child
car seats.
Never secure your child or the child car seat with a 2-pointvehicle-belt. If your child is secured in
the child car seat with a 2-pointvehicle-belt only, it can be seriously injured in an accident.
Do not use vehicle seats, which are arranged to travel backwards or side ways. These seats are
not permitted to use for child car seats.
21

2. Connecting the backrest to the booster seat

The seat consists of a seat cushion and a back with headrest. Only the
combination of the two parts offer maximum protection.
WARNING: The parts of the HEYNER® MaxiFix AERO must not be used indi-
vidually or in conjunction with parts or headrests from other manufactu-
rers or ranges. The license expires immediately in this case.
Lay down the booster (fig.2) on the floor and the backrest (fig.1) flat right
behind. Then thread the connecting hooks (A) on the bottom of the back-
rest into the fitting holes (B) on the back of the booster with a firm dow-
nwards motion. Now bring the backrest slowly upright, 90°to the booster.
The connecting hooks should now slip into the fitting holes with an audible
sound. As the result the backrest should be well fixed to the booster in the
upright position. It must not slip away now. Otherwise you may not have
fixed it very well an using it would be dangerous. In this case please repeat
the first steps of this part of the instruction.
Caution: Always make sure that the parts are firmly mounted. The Items
must not get jammed in by e.g. the vehicle door.

3. Placing it onto the vehicle seat

The HEYNER® MaxiFix AERO child car seat is tested and approved under
the European Standard for Child Restraint Systems ECE 44/04. You will find the certification
mark with the registration number on the back of the seat, see orange label.
22