Icon Identification; Commissioning - Riester ri-former Gebrauchsanweisung

3.1.3 Attaching the wall mounting plates
After you have drilled the holes, take the plugs supplied and push them
into the holes as far they will go.Take the wall mounting plate and hold it
onto the wall so that the screws can be pushed
through the holes of the mounting plate into the plugs. Now screw in the
screws with a screw driver, as far as they will go.
3.1.4 Attachment of the diagnostic station
When all screws have been screwed in tightly, take the diagnostic station
and guide the screw heads through the openings. Remove the sliding co-
ver of the diagnostic station. Then press the diagnostic station downwards
until it snaps into place.
a)
b)
3.1.5 Attachment of the extension module
Connect the diagnostic station and the extension module with the help of
the connecting cable. In order to plug in the connecting cable (a).
Close the casing opening of the extension module, which is not needed,
with the sliding cover (b). Take the extension module and guide the screw
heads through the openings (c). Then press the extension module dow-
nwards.
Attention!
Take care that the connecting cable does not get caught
behind
the extension module. Push the connecting cable into
the groove
provided on the reverse side of the extension module.
c)
3.2

Icon Identification

I
ON
0
OFF
HR
Hour setting for the clock
MIN
Minute setting for the clock
+ -
Dimming the instrument light on the handle
Applied part
Typ B
Attention!
Important note in this instruction use
3.3

Commissioning

3.3.1 Put the wall plug-in into the electrical socket. The optional clock starts
to blink.
You can adjust it to local time by repeatedly pressing the keys; with the
left key marked HR and the right key marked MIN.
3.3.2 Move the handle upwards out of the handle holder and attach the
desired instrument head by placing it with the two projecting guide
cams onto the handle. Press the instrument head lightly onto the hand-
le and turn the handle in a clockwise direction until it stops. Removal
of the instrument head is carried out by turning in a counter-clockwise
direction.
3.3.3 Switching on and off.
Switch on the instrument by using the switching ring. Each handle is
automatically ready to operate at 100% light intensity as soon as it is
taken out of the handle holders.
The handle is switched off automatically by putting back into the handle
holder
The handle is automatically switched off when replaced back into the
handle holder.
3.3.4 rheotronic® for light intensity modulation the modulation of light
intensity can be done with the handle; you only have to tip the switching
ring clockwise direction or against clockwise direction and the light
gets stronger or weaker.
Attention!
The handle gets off automatically after abt. 3 minutes.
Make sure that no more than 2 handles are used at the
same time! If more than 2 handles are used at the same
time, the transformer in the instrument may become
overloaded and switch itself off.
3.4 Diagnostic Station Mobile
ri-former
®
Please follow the assembly instructions for the mobile stand with
ri-former . The assembly instructions is included in the mobile stand
®
delivery package.
3.5 ri-former Diagnostic Station Anesthesia
®
Assembly of the universal clamp.
Please check if the designated wall rail is rigidly mounted on the wall.
Fix the universal clamp on the determinated place of the wall rail and
tighten very well the locking screw . Put the preassembled ri-former
anesthesia device on the universal clamp and insert it. Please ensure
that both pins are introduced in the universal clamp. Afterwards tighten
the ri-former anesthesia device with the lateral screw.
®
®
17