Spare Parts; Waste Disposal And Environmental Protection; Possible Cause - Ikra XL 30 SSB Gebrauchsanweisung

4. Prepare the device for operation.
5. Fill the tank with the proper fuel/oil mixture. See chapter
'Fuels and lubricants'.

SPARE PARTS

Please contact our service department if you need acces-
sories or spare parts.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts not
recommend by us can result in serious injuries to persons
or damage to the machine.
CORRECTING FAILURES OF THE ENGINE
PROBLEM
Engine does not start or starts,
but does not run further.
Engine starts, but does not run at full power.
Engine splutters.
No power under load.
Engine does not run smoothly.
Excessive exhaust gases (smoke).
Downloaded from www.Manualslib.com

POSSIBLE CAUSE

Wrong starting process.
Wrong setting of the carburettor.
Fouled spark plug.
Clogged fuel filter.
Wrong choke lever position.
Dirty/clogged spark grid.
Dirty/clogged air filter.
Wrong setting of the carburettor.
Wrong setting of the carburettor.
Wrong setting of the spark plug.
Wrong setting of the carburettor.
Improper fuel mixture.
manuals search engine
WASTE DISPOSAL AND ENVIRONMENTAL
PROTECTION
Never pour remainders of chain lubricant or 2-stroke fuel
mixture in the drain or sewerage system or soil, but dispose
of it in a proper, environmentally friendly way, e.g., at a
special collecting point or dump.
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Thoroughly empty the oil/lubricant and fuel tanks and
dispose of the remainders at a special collecting point
or dump. Please also dispose of the device itself at an
according collecting/recycling point. By doing so, plastic
and metal parts can be separated and recycled. Informa-
tion concerning the disposal of materials and devices are
available from your local administration.
CORRECTION
Refer to the instructions in these
operating instructions.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Clean/adjust or replace spark plug.
Replace the fuel filter.
Put the lever to position RUN (OPERATION).
Replace the spark grid.
Remove, clean and reassemble filter.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Clean/adjust or replace spark plug.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Use the proper fuel mixture (ratio – 40:1).
GB-9