Ec Declaration Of Conformity - Atlas Copco ETD SR21-07-I06-PS Original-Produktanweisungen

Safety Information
Trouble-shooting and re-start of the system may
only be carried out by an authorized person.

EC DECLARATION OF CONFORMITY

We, Atlas Copco Industrial Technique AB,
S-105 23 STOCKHOLM, SWEDEN declare that
the product (with name, type and serial number,
see front page) is in conformity with the following
Directive(s):
2006/42/EC, 2011/65/EU, 2014/30/EU
Harmonised standards applied:
EN 61000-3-2:2006, EN 61000-3-3:2008, EN
61000-6-2:2005, EN 61000-6-4:2007, EN
61010-1
Technical file available from:
Quality Manager, Atlas Copco Industrial Tech-
nique, Stockholm, Sweden
Stockholm, 1 July 2013
Tobias Hahn, Managing Director
Signature of issuer
RoHS and WEEE
Information concerning Restriction of Hazardous
Substances (RoHS):
This product and its information, meets the re-
quirements of the RoHS Directive (2011/65/EU).
Information concerning Waste of Electrical and
Electronic Equipment (WEEE):
This product and its information, meets the re-
quirements of the WEEE Directive (2012/19/EU),
and must be handled according to the directive.
The product and/or its battery are marked with a
crossed trashcan, see figure below.
The symbol indicates that parts within the product
must be handled in accordance with the WEEE Di-
rective. These parts are indicated as "WEEE" in
the Spare part list, see under Remarks.
The entire product, or the WEEE parts, can be sent
to your "Customer Centre" for handling.
4 © Atlas Copco Industrial Technique AB - 9836 7094 00
For more information, consult the website
http://www.atlascopco.com/.
Choose Products - Links and downloads, and
click EU RoHS and WEEE directives (ENG-
LISH only).
Installation
Installation
The tool should, via its correct drive unit, be con-
nected to the mains, 230V/ 50Hz alternatively
115V/ 60Hz, single phase. See instructions for
your drive unit.
Fitting of the tool cable:
• Security check that the cable type is correct
• Align the cable connector using the two asym-
metrically positioned slots on the connector to
fit in the heads in the tool
• Tighten the lock nut
• Security check that the connection is correct by
pulling, pushing and turning the cable connec-
tor (there should be no movement).
Grounding
If the tool is mounted in a handheld or handguided
fixture, the fixture should be connected to the drive
using a separate 2.5mm
Handling
Operating
Make sure that the tool is in correct working order
and that the controller is correctly programmed to
avoid unexpected behaviour from the tool, which
may result in operator injury.
Check that the tool is in the correct running direc-
tion by looking at the function light situated above
the tool handle.
The soft-start function facilitates entering the
screw head and thread.
The duration of the soft start is adjustable, see the
manual for the drive unit.
The tool is equipped with signal lights,
• Green = OK tightening.
• Yellow = Warning – low torque.
• Red = Not OK tightening.
ETD SR21-07-I06-PS
2
grounding cable.