Parkside PASSK 20-Li A1 Originalbetriebsanleitung Seite 21

battery PAP 20 A3*
Type
Rated voltage
Capacity
Cells
NOTE
► Note that the full performance of the unit can
only be achieved if the PAP 20 A3 battery is
used.
High-speed battery charger PLG 20 A3*
INPUT
Rated voltage
Rated power consumption 120 W
Fuse (internal)
OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT INCLUDED
Noise emission value
Noise measurement value determined in
accordance with EN 62841. The A-rated noise
level of the power tool is typically:
Sound pressure level
Uncertainty K
Sound power level
Uncertainty K
PASSK 20-Li A1
LITHIUM ION
20 V (DC)
4 Ah
10
230–240 V ∼,
50 Hz (AC)
T3.15A
3.15 A
21.5 V (DC)
4.5 A
approx. 60 min
II /
(double insulation)
L = 91.6 dB (A)
PA
K = 3 dB
PA
L = 102.6 dB (A)
WA
K = 3 dB
WA
Vibration emission value
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Tightening screws and nuts of maximum permissible
size
Uncertainty
Wear hearing protection!
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
► Try to keep the load as low as possible.
Measures to reduce the vibration load are,
e.g. wearing gloves and limiting the working
time. Wherein all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
a = 8.65 m/s 2
h
K = 1.5 m/s 2
GB │ IE │
17 ■