Operating The Machine; Before Starting The Machine - Nilfisk SR 1601 D3 Betriebsanleitung, Originalanleitung

ENGLISH
Diesel and Petrol Engine (SR 1601 D3 / SR 1601 P3)
1. Unscrew the fuel tank plug (21) and refuel.
2. (Only for SR 1601 D3) If using the machine when the outside temperature is lower than 32 °F (0°C), use diesel fuel for low
temperatures.
3. (Only for SR 1601 P3) Unscrew the plug (21) and fill the tank (22) with unleaded fuel for vehicles.
NOTE
If the machine runs out of fuel completely, the fuel system must be bled before the engine can be re-started. To avoid
this situation, fill the fuel tank (22) until the fuel indicator (56) indicates 1/4 of the tank. Fuel tank capacity is 14 USgal (35
litres).
LPG Engine (SR 1601 LPG3)
DANGER!
Before replacing the LPG tank, close the safety valve and disconnect the hose.
1. Install an LPG tank (50) having characteristics which comply with the laws in force in the country where it used.
2. Connect the fuel hose and open the cutoff valve on the LPG tank. Always wear gloves when connecting and disconnecting the
fuel hose. When the machine is not operating, close the LPG tank safety valve.
NOTE
Place the LPG tank in a proper horizontal position. Connect the hose to the tank and check that there are no gas leaks.
DANGER!
Do not use the machine in case of gas leaks. Disconnect the hose and replace the LPG tank. If the gas leak
persists, disconnect the fuel hose and contact the Nilfisk Service Center.

OPERATING THE MACHINE

The SR 1601 is a rider-type automatic floor sweeping machine. The controls were designed to be user friendly. For single pass
sweeping the operator can simply lower the main broom.

BEFORE STARTING THE MACHINE

1. Be sure to understand the operating controls and their functions.
2. Plan the cleaning route. Arrange long, straight passes with as few turns as possible.
3. Check the brake pedal (35). The pedal should be firm.
WARNING!
If the pedal is "spongy" or fades under pressure, do not drive the machine.
Report all defects immediately to service personnel.
Filling the dust guard system water tank (optional)
1. Remove the plug (29) to reach the filler neck.
2. Fill the tank (4) with clean water. Do not fill the tank completely, leave a few centimetres from the edge.
18
Downloaded from www.Manualslib.com
USER MANUAL
SR 1601 D3 / LPG3 / P3 - 33019216
manuals search engine