Troubleshooting - Nilfisk SR 1601 D3 Betriebsanleitung, Originalanleitung

TROUBLESHOOTING

The machine does not move
The main broom does not turn
The machine collects little debris/dust
The side broom does not operate
The hopper dumping door does not close
The filter shaker motor does not work
The dust guard system (optional) does
not work
(*) Procedure to be performed by Nilfisk Service Center.
For further information contact a Nilfisk Service Center, where it is possible to consult the Service Manual.
Downloaded from www.Manualslib.com
Trouble
The battery is disconnected
The machine has run out of fuel
The fuses are tripped
The parking brake is engaged
The unlocking screw is not in a proper position Turn it properly
The main broom is lifted
Debris wrapped around the broom drive
The hopper is not fully lowered
The vacuum system is off
The dust filter is clogged
The hopper is full
The skirts are damaged or misadjusted
The main broom height is incorrect
The fuses are tripped
The side broom is lifted
Debris wrapped around the broom drive
The hopper is not fully lowered
The dumping door is jammed by debris
The filter shaker motor connector is not
properly connected
The fuse is tripped
The switch is faulty
The nozzles or the water filter are clogged
The pump is faulty
The fuse is tripped
manuals search engine
USER MANUAL
Possible Cause
Connect the battery
Refuel
Reset any tripped fuse
Disengage
Lower the main broom with the lever
Remove debris
Fully lower the hopper
Turn on the vacuum system with the switch
Clean the dust filter
Empty the hopper
Check the skirt for integrity and proper adjustment (*)
Adjust the main broom height
Reset any tripped fuse
Lower the side broom with the lever
Remove debris
Fully lower the hopper
Remove debris and clean edges of dirt chamber
Connect it properly
Reset the tripped fuse
Replace the switch (*)
Clean
Replace
Reset the tripped fuse
33019216 - SR 1601 D3 / LPG3 / P3
ENGLISH
Remedy
33