Nilfisk SR 1601 D3 Betriebsanleitung, Originalanleitung Seite 77

WARNING!
– (Only for versions equipped with dust guard system) Pay attention during machine transport when
– Do not remove or modify the plates affixed to the machine.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary, request
– If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
– While the engine is running, the silencer warms up; do not touch the silencer when it is hot to avoid burns or
– Running the engine with an insufficient quantity of oil can seriously damage the engine. Check the oil level
– Never run the engine if the air filter is not installed, because the engine could be damaged.
– Technical service procedures on the engine must be performed by an authorised Dealer.
– Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality
– See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of this Manual.
Guide lines to bacteria control and other dangers coming from the presence of microbes in the dust guard system.
WARNING!
To prevent the operators and other people from developing infections caused by microbes and Legionella that
may flourish in the dust guard system, take the following precautions:
– If possible, fill the tank with cold water (< 20°C).
– DO NOT use stagnant water to fill the tank.
– DO NOT use recycled water, undrinkable water or water that has been in contact with the soil.
– Adjust and turn the nozzles towards the floor only, from preventing possible inhaling.
– Do not store the machine outdoors or near sources of heat.
– Do not over-fill the tank. Fill the tank sufficiently so that it can be emptied by using the system.
– Empty the tank every 10 hours or once a week, according to the use.
– If the machine is not used for more than one week, empty the tank completely, and let it dry.
– If the tank cannot be cleaned regularly, consider using a biocide that can kill or exert a controlling effect on
– If chemical products have to be used in the water tank, it is mandatory to apply the relevant information and
Downloaded from www.Manualslib.com
temperature is below freezing point. The water in the system tank or hoses could freeze and seriously
damage the machine.
assistance from the authorised personnel or from an authorised Service Center.
this Manual, must be performed by the authorised personnel or by an authorised Service Center.
oils, plastics, etc.), which are subject to standards that require disposal in special centres (see the Scrapping
chapter).
fires.
with the engine off and the machine on a level surface.
can seriously damage the engine.
Legionella bacteria. Biocide must be chosen according to the local regulations and must be used according
to the relevant instructions and cautions, to avoid that the personnel gets affected by dangerous chemical
substances.
caution labels of the product.
manuals search engine
USER MANUAL
33019216 - SR 1601 D3 / LPG3 / P3
ENGLISH
7