Sweeping - Nilfisk SR 1601 D3 Betriebsanleitung, Originalanleitung

ENGLISH

SWEEPING

Follow the instructions in Preparing The Machine For Use paragraph.
1. Drive the machine to the work area as shown in the previous paragraph.
2. If the hopper is not already lowered, lower it properly by using the lever (54).
3. Lower and turn on the main broom with the lever (53).
NOTE
The side and main brooms can be lowered and lifted even when the machine is moving.
The brooms do not turn when they are lifted or when the machine is stationary.
NOTE
The hopper dumping door opens automatically when the main broom lowers and closes automatically as soon as the
main broom is lifted.
4. Press the upper part of the switch (69) to turn on the vacuum fan and the dust guard system.
WARNING!
When working on wet floors, turn off the vacuum fan and the dust guard system with the switch (69) to preserve
the dust filter.
Turn on the vacuum fan and the dust guard system as soon as the machine returns to a dry floor.
5. Lower and turn on the side brooms (9) (15, equipped on SR 1601 MAXI) with the lever (52).
If equipped, turn on the dust guard system with the switch (70, optional).
6. Drive the machine straight forward at a quick walking speed. Drive the machine slower when sweeping large amounts of dust
or debris or when safe operation dictates slower speeds. Overlap passes 5.9 in (15 cm).
7. For proper machine operation, the dust filter must be as clean as possible. To clean the dust filter while sweeping, turn on the
filter shaker by pressing the lower part of the switch (69), then turn on the vacuum fan and the dust guard system by pressing
the upper part of the switch (69) after shaking has completed.
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
This procedure can also be performed when the machine is moving.
CAUTION!
When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore.
8. Check behind the machine occasionally to make sure that the machine is picking up debris. Dirt left behind in the path of the
machine usually indicates that the machine is moving too fast, the main broom needs to be adjusted, or the hopper (47) is full.
The hopper (47) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph).
20
Downloaded from www.Manualslib.com
USER MANUAL
SR 1601 D3 / LPG3 / P3 - 33019216
manuals search engine