6 Commissioning
6.2 Adjusting the TCP
1
1
Hexagon nut M8
2
Dowel screw M6
Fig. 10
1 Loosen the hexagon nut (1) and adjust the torch mount (3) to the desired TCP.
2 Tighten the hexagon nut (1).
To secure the adjusted position proceed as follows:
3 Drill through the bracket (6) with a Ø of 5.8 mm bit and ream a hole for the dowel screw (2)
with a reamer (for 6H7).
4 Fix both torch mounts (6), (3) with a dowel screw (2) and hexagon nut (4).
4 Scope of delivery on page EN-11
EN - 16
2
3
3
Torch mount
4
Hexagon nut M6
Adjusting the TCP
4
5
5
6
CAT3Pro
6
Dowel screw M8
Bracket
BAL.0843.0 • 2020-11-03