Troubleshooting - Scheppach HS105 Original Bedienungsanleitung

16. Troubleshooting

Fault
Blade dissolves after
switching off the engine
Engine will not start
Motor wrong direction
of rotation
Motor will not work, the
fuse is active
Fire marks on the
cutting surface
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes
To slightly tightened fastening nut
Failure mains fuse
Defective extension cable
Connections on motor or switch not in order
Motor or switch faulty
Capacitor faulty
Wrong connection
Cross section of the extension cable is not
sufficient
Overload by a blunt saw blade
Blunt saw blade
Wrong saw blade
Action
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
Repair by electrical specialist
Exchange polarity of outlet by an qualified
electrician
See „Electrical connection"
Change saw blade
Sharpen or change saw blade
Change saw blade
GB | 39