Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.2. Using the stand
Use your meter's stand to prop up the meter. If you prop
your meter on a bench-top, the stand helps provide a better
viewing angle.
To use the stand as a prop, just open it away from the meter
and set it on a flat surface.
6. How to make measurements
Understanding Phantom readings:
In some DC and AC voltage ranges, when the test leads are
not connected to any circuit, the display might show a
phantom reading. This is normal. The meter's high input
sensitivity produces a wandering effect. When you connect
the test leads to a circuit, accurate reading appear.
6.1. Measuring AC/DC voltage
WARNING!
Do not try to measure a voltage greater than 1000V DC or
AC. You might damage your meter and expose yourself to a
severe shock hazard.
Follow these steps to measure DC/AC Voltage.
1. Set the rotary selector to the desired position. Select the
range as required for the voltage level to be measured. If
you do not know the voltage level, start with the range
switch set to the highest voltage position and reduce the
setting as needed to get a reading.
2. Plug the black test lead into the meter's COM terminal
and the red test lead into the V//Hz-terminal.
3. Connect the test leads to the DC/AC voltage source you
want to measure.
47
Werbung
