Werbung
Verfügbare Sprachen
Verfügbare Sprachen
*
Current measurements are always carried out in series
with
the
disconnected.
*
Remove the test probes from the measurement object
before changing the measuring function.
*
Never
touch
measurement, only hold the test leads by the handle
behind the finger guard. If applicable, discharge any
capacitors before measuring the circuit to be measured.
*
The thermocouple for temperature measurements is
made of conductive material. To avoid electric shock,
never connect it with a live conductor.
Measurement environment:
*
Avoid any proximity to explosive and flammable
substances, gases and dust. An electric spark could
lead to an explosion or deflagration - danger to life!
*
Do
not
environments, the device could be damaged or contact
points inside and outside the device could corrode.
*
Avoid working in environments with high interference
frequencies, high-energy circuits or strong magnetic
fields, as these can negatively affect the multimeter.
*
Avoid storage and use in extremely cold, humid or hot
environments, as well as long exposure to direct sun.
*
Only use devices in damp or dusty environments in
accordance with their IP protection class.
*
If no IP protection class is specified, only use the device
in dust-free and dry indoor rooms only.
*
When working in damp or outside areas, pay particular
attention to completely dry handles on the test probes.
*
Before starting the measuring operation, the device
should be stabilized at the ambient temperature
(important when transporting from cold to warm rooms
and vice versa)
consumer,
the
bare
carry
out
i.e.
with
test
probes
measurements
34
the
supply
during
in
corrosive
line
the
Werbung
