Only Use Tool In Well Ventilated Area - Max GS738C LT Betriebsanleitung

(1) Check whether or not operating sound is heard, by
only connecting the Battery.
* If you connect the Battery and press the contact arm
against the floor, and so on, the fan of the tool will
run, but this is not abnormal.
(2) Check for heat generation or abnormal smell or sound.
If the tool is activated, generates the heat or emits ab-
normal smell or sound, it is an indication of trouble.
Using the tool in that condition results in an accident.
If any abnormality is found, contact your nearest au-
thorized distributor.
8. UNPLUG THE CHARGER WHEN IT IS NOT USED
9.

ONLY USE TOOL IN WELL VENTILATED AREA

If used in an ill-ventilated place, you could suffer from oxy-
gen starvation.
10. AVOID THE DIRECT SUNSHINE
Do not place the tool in a vehicle or a trunk where the tem-
perature could rise, because it could explode. A used empty
Fuel Cell still contains a combustible jet gas, which could
swell and explode a container into pieces.
Thinner
11. NEVER USE THE TOOL NEAR THE VOLATILE COM-
BUSTIBLE SUBSTANCES
Never use the tool near gasoline, thinner, gas, paint or ad-
hesive agent, because it could ignite or explode.
12. KEEP TOOL AWAY FROM FIRE
13. BE SURE TO USE THE TOOL IN THE WORKING ENVI-
RONMENT OF -10°C (14°F) TO 40°C (104°F), BECAUSE
THE TOOL BODY COULD BE DAMAGED, IGNITE OR
EXPLODE
-10°C (14°F) or lower: The tool body could be damaged.
40°C (104°F) or higher: The Fuel Cell could be damaged,
resulting in ignition or explosion.
14. DO NOT USE THE TOOL IN THE RAIN OR IN A VERY
HUMID PLACE
Neglect of this causes a trouble.
15. NEVER DRIVE THE PINS, FACING EACH OTHER
If you drive the pins, facing each other, an improperly driven
pin may hit and injure the worker facing you.
7
Gasoline