Instructions For Operation; Before Operation - Max GS738C LT Betriebsanleitung

DISPOSING OF THE USED FUEL CELL
Combustible jet gas still remains in the used Fuel Cell.
WARNING
• Do not throw the used Fuel Cell into a fire.
• Never smoke a cigarette.
• Never breathe in the gas.
6. INSTRUCTIONS FOR OPERA-
TION
Read section titled "SAFETY INSTRUCTIONS".
1.

BEFORE OPERATION

1 Wear Safety Glasses or Goggles.
2 Do not insert the Fuel Cell and Battery.
3 Inspect screw tightness.
4 Check operation of the Contact Arm & Trigger if moving
smoothly.
5 Insert the Fuel Cell and Battery.
6 Hold the tool with finger-off the Trigger, then push the Con-
tact Arm against the work-piece. (The tool must not oper-
ate.)
7 Hold the tool with Contact Arm free from work-piece and pull
the Trigger. (The tool must not operate.)
8 Remove the Fuel Cell and Battery.
WARNING
2. OPERATION
Wear safety glasses or goggles
Danger to the eyes always exists due to the possibility of dust be-
ing blown up by the exhausted air or of a fastener flying up due
to the improper handling of the tool. For these reasons, safety
glasses or goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection
is worn. Eye protection equipment must conform to the require-
ments of the American National Standards Institute, ANSI Z87.1
(Council Directive 89/686/EEC of 21 DEC. 1989) and provide
both frontal and side protection.
The employer is responsible to enforce the use of eye protection
equipment by the tool operator and all other personnel in the work
area.
NOTE: Non-side shielded spectacles and face shields alone do
not provide adequate protection.
WARNING
Keep hands and body away from the discharge outlet
When driving the fasteners because of dangerous of hitting the
hands or body by mistake.
LOADING THE PINS
WARNING
• When loading the pins, be sure to release the finger from
the Trigger.
• Do not press the Contact Arm against the object.
Procedure
1 Load the pins into the slit in the rear of the Magazine until
they reach in front of the Nail Stopper.
CAUTION
• Abrupt release of the Follower Holder causes jamming of
pins or dry-firing.
2 Pull the Follower Holder as far to the rear and of the maga-
zine and release it gently.
15
Pin
Nail Stopper
(Back side)
Follower
Holder