Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-22
Start-up
Setting up and adjusting
the appliance (free standing
appliance)
NOTICE
Risk of damage
If the ventilation slits are covered, the
heat from inside the appliance cannot
be properly expelled.
Make sure that the ventilation slots
■
are not covered.
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using the four screw feet.
– Ensure the glass door (2) is closed.
– Tilt the appliance backwards slightly and
screw in/unscrew the screw feet (4).
– Tilt the appliance slightly forward and
screw in/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
glass door.
Integrating the appliance into
a kitchen unit
Risk of damage
If the ventilation slits are covered, the
heat from inside the appliance cannot
be properly expelled.
Make sure that the ventilation slots
■
are not covered.
The appliance can be integrated into a kitch-
en unit if necessary. The recess dimensions
can be found in the diagram on page EN-21.
1. First connect it to the power.
2. Slide the appliance into the recess. Make
sure that the mains cord does not be-
come trapped.
Cleaning before use
To remove the odour that comes with all
new appliances, clean the appliance before
using it (see "Care and maintenance" on
(4)
page EN-16).
Connecting the appliance
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if it
–
–
–
NOTICE
WARNING
shows visible signs of damage, e.g.
the power cord is defective,
starts smoking or there is a smell of
burning,
makes unfamiliar noises.
Werbung
Kapitel
Inhaltsverzeichnis
