Risk of damage
NOTICE
If the appliance has been transported
horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Do not tilt the appliance more than
■
45° or lay it on its side.
Allow the cooling unit to stand up-
■
right for two hours before start-up.
The lubricant will fl ow back into the
compressor during this time.
Improper handling of the appliance
can lead to damage to property.
Do not use the door to pull or lift the
■
appliance.
The appliance must only be placed
■
on a level and fi rm surface. The sur-
face must be strong enough to sup-
port the appliance's weight when ful-
ly laden.
Do not use the appliance near sinks,
■
taps or containers fi lled with liquids
(e.g vases, aquariums). Make sure
that the appliance does not get wet.
The maximum load of 22 bottles per
■
bottle shelf must not be exceeded.
Do not use sharp or pointed objects
■
to unpack it.
Safety
When cleaning, please note:
■
Never use harsh, granular, soda, ac-
–
id, solvent-based or abrasive clean-
ers. These attack the plastic sur-
faces. All-purpose cleaners with a
neutral pH are recommended.
Door seals and plastic parts are
–
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
Do not clean the appliance parts in
–
the dishwasher.
Use only soft cloths for cleaning.
–
Wait 5 minutes after switching off.
■
Only then switch the appliance on
again.
Page EN-9