Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-20
Start-up
About climate categories
• Always ensure the prescribed ambient temperature is maintained (see "Intended use" on
page EN-4).
Climate category means that the appliance is intended for operation at the specified ambient
temperature (see table "climate categories"). If the room temperature drops significantly below
this, the unit will not switch on as often. This indicates that an unwelcome increase in temper-
ature may occur.
"Climate categories" table
Zone description
Extended temperate zone
Temperate zone
Subtropical zone
Tropical zone
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure adequate air circulation, do not
place the appliance directly against the
wall. Leave a gap of at least 10 cm to the
back wall and 5 cm to the side.
3. Check the position with a spirit level.
4. Level out any unevenness on the ground
using both of the front screw feet.
– Close the glass door (1).
Code
Definition
This refrigerator is designed for use at ambient temper-
SN
atures of +10 °C to +32 °C.
This refrigerator is designed for use at ambient temper-
N
atures of +16 °C to +32 °C.
This refrigerator is designed for use at ambient temper-
ST
atures of +16 °C to +38 °C.
This refrigerator is designed for use at ambient temper-
T
atures of +16 °C to +43 °C.
– Tilt the appliance backwards slightly and
– Stand the appliance back up again and
Cleaning before use
• To remove the odour that comes with all
new appliances, clean the appliance be-
fore using it (see "Care and maintenance"
on page EN-16).
(2)
screw in/unscrew the screw feet (2).
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
glass door.
Werbung
Inhaltsverzeichnis
