Setting Up And Adjusting The; Integrating The Appliance Into A Kitchen Unit; Basic Cleaning - hanseatic JCF-88S Gebrauchsanleitung

Page EN-20 Start-up
Setting up and adjusting
the appliance (free standing
appliance)
NOTICE
Risk of damage
If the ventilation slits are covered, the
heat from inside the appliance cannot
be properly expelled.
Make sure that the ventilation slots
■
are not covered.
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using the four screw feet.
– Close the glass door (1).
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet (2).
– Tilt the appliance slightly forward and
screw in/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
glass door.
Integrating the appliance into
a kitchen unit
Risk of damage
If the ventilation slits are covered, the
heat from inside the appliance cannot
be properly expelled.
Make sure that the ventilation slots
■
are not covered.
The appliance can be integrated into a kitch-
en unit if necessary. The recess dimensions
can be found in the diagram on page EN-19.
1. First connect it to the power.
2. Slide the appliance into the recess. Make
sure that the mains cord does not be-
come trapped.

Basic cleaning

To remove the odour that comes with all new
appliances, clean the appliance before us-
(2)
ing it (see „Care and maintenance" on page
EN-15).
NOTICE