Changing The Door Hinges - hanseatic HWC171GCIA Gebrauchsanleitung

In such cases, remove the mains plug
from the socket and contact our Ser-
vice department (see page EN-29).
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
Do not kink or pinch the mains cord
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
Connect the appliance only to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~/50 Hz).
The temperature indicators (14) and (15)
will light up. The appliance is switched on.
You will find all important information
about operation from page EN-11.
Start-up

Changing the door hinges

WARNING
Risk of injury!
The glass door is very heavy (27 kg). Im-
proper use of the glass door may lead
to injuries.
It is necessary to ask one or prefera-
■
bly two other person(s) to help you
with the process of mounting or re-
moving the glass door.
Wear safety shoes when helping.
■
NOTICE
Risk of damage!
Improper handling of the appliance
may result in damage.
Do not tilt the appliance more than
■
45°.
Do not lay it on its side.
■
Depending on the space conditions, you can
change the direction of the door hinges on
your appliance. This work, however, requires
you to have a certain degree of craftsmanship
skills. Please read the following steps com-
pletely before changing the hinges.
You will need the following tools to change
the door hinges:
– Medium size cross-tip screwdriver
– Medium size flat-headed screwdriver
Page EN-23