Setting Up And Adjusting The Device (Free Standing Device); Integrating The Device Into A Cupboard Or Kitchen Unit; Basic Cleaning - hanseatic JCF-145S Gebrauchsanleitung

Page GB-20 Start-up
Setting up and adjusting the
device (free standing device)
NOTICE
Risk of damage
If the ventilation slits are covered, the
heat from inside the device cannot be
properly expelled.
Make sure that the ventilation slots
■
are not covered.
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using both of the front screw feet.
– Close the glass door (1).
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet (3).
– Stand the appliance back up again and
Integrating the device into a
cupboard or kitchen unit
Risk of damage
If the ventilation slits are covered, the
heat from inside the device cannot be
properly expelled.
Make sure that the ventilation slots
■
are not covered.
The device can be integrated into a cupboard
or kitchen unit if necessary. The recess di-
mensions can be found in the diagram on
page GB-19.
(3)
1. First connect it to the power.
2. Slide the device into the recess. Make
sure that the mains cord does not be-
come trapped.

Basic cleaning

To remove the odour that comes with all new
appliances, clean the appliance before us-
ing it see „Care and maintenance" on page
GB-15).
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
glass door.
NOTICE