Elica Glide Serie Montage- Und Gebrauchsanweisung Seite 62

Note: wait 10 seconds without pressing any other command,
so that the countdown starts.
The format of the Timer is
- . for the times
- for the minutes
Note: the timer can be set up to a maximum of 1h and 59min.
In the Zone/Display (4) the remaining time will be displayed;
at the end of the countdown, an acoustic signal will sound
Note: in the display of the countdown, for a time less than 10
minutes, the following format is evident
- . minutes
- seconds
with fixed light point
To switch off the Timer:
• select Zone/Display (4)
• set the duration of the Timer to
Cooking Zones Timer
The Cooking Timer Zone function is a countdown that can be
set, also at the same time, on each cooking zone
At the end of the period set, the cooking zones switch off
automatically and the user is notified with a dedicated acoustic
signal.
Activation of the cooking zone timer function
• Touch (press) the Selection/Display area (2)
(power level ¹0)
• Press (6) relating to the cooking zone
Use the symbols
of the Timer, which is displayed in the Zone/Display (4)
during setting the symbol
Note: wait 10 seconds without pressing any other
command, so that the Cooking Zone Timer will start.
Note: by pressing and holding
cooking zone timer is reset
If desired, repeat the operation for several cooking
zones.
Note: each cooking zone can have a different Timer set; in
the display (4) he countdown of the cooking zone selected
at that moment will appear; if no zone is selected, pressing
the Display (4) will display the "STAND-ALONE" Timer
countdown.
The countdown mode is the same as the "STAND-
ALONE" timer one (see previous paragraph "STAND
ALONE" Timer)
.
, via
(5) to set the duration
(6) is flashing
(6) , the
When the timer has finished the countdown, an acoustic
signal sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to
Power Limitation
The Power Limitation function allows the product to be used
while limiting its maximum absorption, adjusting the absorbed
power in all active cooking zones, ensuring the hob's total
absorbed power doesn't exceed the set maximum absorption
level.
Note: the setting must take place with the hob off, without
pressing the
connected to the mains, or when the electric mains are
(5)
reconnected within the following 2 minutes.
To set the Power Limitation:
- press
(which will be flashing, only for the first 2 minutes after
powering of the product)
- continuing to hold down
areas of Selection/Display (2) of the cooking zones, anti-
clockwise starting from the front right zone (FR)
- each press will be accompanied by a short audible signal
- once all the Displays (2) have been pressed, it will be
possible to release the key
at this point:
- the Display (2) of the left rear zone (RL) will show in
alternate sequence the symbols
is possible to perform the setting:
61
ON/OFF (1) key, when the hob is
press, one at a time, all the
" "
C and
select the Display (2-RL)
, using (5)
" "
0 , indicating that it