Chapter V Packaging - SATA AE5601 Bedienungsanleitung

中文
EN DE RU KO PT JA ES
AE5601

Chapter V Packaging

Since the wheel aligner is a precision measuring instrument, its soft packaging shall be soft enough, and its rigid packaging shall be rigid
enough.
The specific packaging steps are as follows: wrap the single item in multiple layers of EPE (depending on the specific condition of the item),
and then fasten them with the adhesive tape or stretch film tightly. After the soft packaging of the cross beam is completed, the cross beam
placed in the wooden case and the lens shades on both ends shall not have come into contact with the wooden case. The cabinet shall be
fixed to the base of the wooden case. Cut the foam block into the size of the wooden case (the thickness of the foam block depends on the
specific condition of the item), put the foam block and the well-packaged single item into the wooden case successively, put the filler into
透明度拼合
the wooden case to prevent the item from shaking in the case, put the cover plate made of foam block in there, properly fix the upper cover
plate of the wooden case, and then make such marks as "Fragile", "No collision" and "Keep off rain" that must be noted during handling and
transportation on the wooden case. (The figure shown below is for reference only.)
This Side Up Keep Dry
Fragile
Do Not Turn Over
66