Bosch ACS 753 Originalbetriebsanleitung Seite 73

Message on the display
Out of range
ISV pressure sensor
Out of range
ISV temperature
Out of range
Low pressure side pressure
sensor
Power board communication
failed
Unsuccessful pressure test
Check for leaks
Empty external tank
Full tank. Remove refrigerant
from the internal tank before
continuing
Expired trial time.
Activation of the required unit
to continue using it.
Activate now?
Vacuum test failed. Check for
leaks
Robert Bosch GmbH
Cause
The internal tank pressure transducer does
not correctly read the pressure.
The internal tank temperature sensor does
not correctly read the temperature.
The low pressure side pressure transducer
does not correctly read the pressure.
The communication with the power board
failed
There is a leak in the A/C system of the ve-
hicle.
Failure to transfer refrigerant to the inter-
nal tank because the external tank is emp-
ty.
Internal tank too full to recover more re-
frigerant.
Failure to register and activate the machine
within 30 days of initial start-up causes the
machine to lock and the impossibility to
use it.
There is a leak in the A/C system.
Diagnostic messages | ACS 753 | 73 |
Solution
Exit the current check and contact an authorized
Bosch service center for more information.
Exit the current check and contact an authorized
Bosch service center for more information.
Exit the current check and contact an authorized
Bosch service center for more information.
Restart the station. If the problem persists, contact
an authorized Bosch service center for more infor-
mation.
Exit the current test and repair the A/C system of
the vehicle.
Exit the current test and replace the external tank.
Perform a refilling process to remove refrigerant
from the internal tank before performing any further
recovery attempt.
Select and see the Unit activating section of this
manual to register the station.
Exit the current test and repair the A/C system of
the vehicle.
1 689 989 612
en
|
2020-12-01